2007 Chrysler Town And Country Tail Light Not Working

Using a 12 volt tester it indicated there was no power to either 15 amp fuses for the lights.

2007 chrysler town and country tail light not working.

There could also be an issue with the bulb sockets or the circuit boards inside the lamp housings if they look ok with a visual inspection you can use a test light to check for power at the lamp housing connector when pressing the brake or with the turn signals on if the circuits do light a test light then you know the problem is right there at the lamp housing. Directional s brake and 4 ways. Changed with known goof lamp still would not light. The contact maneuvered to the side of the road and immediately exited the vehicle.

The contact stated that while driving approximately 60 mph the rear passenger tail light ignited into flames. Turn signals and brake lights working. Brake light turn signal and back up work fine. Tail lights not working 2005 town and country.

2006 town and country drivers tail light was out. If you are reading this article trying to figure out whether you should drive your vehicle. I took 2 14 gage wires put the 2 ends of one side and put them together touched this end to the positive side of the battery and the 2 ends of the other side of. Changed lamp still would not light.

All the other lights works.